Boss Audio Systems RIP-496 Owner's Manual Page 258

  • Download
  • Add to my manuals
  • Print
  • Page
    / 356
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 257
Traction
--
A,
B,
C
The traction grades, from highest to lowest, are
A,
B,
and
C,
and they represent the tire’s ability to stop
on
wet
pavement as measured under controlled conditions
on
specified government test surfaces of asphalt and concrete.
A
tire marked
C
may have poor traction performance.
Warning: The traction grade assigned to this tire is based
on
braking (straightahead) traction tests and does not
include cornering (turning) traction.
Temperature
--
A,
B,
C
The temperature grades are
A
(the highest),
B,
and
C,
representing the tire’s resistance to the generation of
heat and
its
ability to dissipate heat when tested under
controlled conditions on a specified indoor laboratory
test wheel. Sustained high temperature can cause the
material of the tire to degenerate and reduce tire life, and
excessive temperature can lead to sudden tire failure.
The grade
C
corresponds to a level of performance
which all passenger car tires must meet under the
Federal Motor Vehicle Safety Standard
No.
109.
Grades
B
and
A
represent higher levels of performance on the
laboratory test wheel than the minimum required
by
law.
Warning: The temperature grade for this tire is
established for a tire that
is
properly inflated and not
overloaded. Excessive speed, underinflation, or
excessive loading, either separately or in combination,
can cause heat buildup and possible tire failure.
Wheel Alignment and Tire Balance
The wheels on your vehicle were aligned and balanced
carefully at the factory to give you the longest tire life
and best overall performance.
In most cases, you will not need to have your wheels
aligned again. However, if you notice unusual tire wear
or your vehicle pulling one way or the other, the
alignment may need to be reset.
If
you notice your
vehicle vibrating when driving on a smooth road, your
wheels may need to be rebalanced.
Wheel Replacement
Replace any wheel that
is
bent, cracked, or badly rusted
or corroded. If wheel nuts keep coming loose, the wheel,
wheel bolts and wheel nuts should be replaced. If the
wheel leaks air, replace
it
(except some aluminum
wheels, which can sometimes be repaired). See your
Chevrolet/Geo dealer if any of these conditions exist.
Your dealer will know the kind of wheel you need.
Each new wheel should have the same load-carrying
capacity, diameter, width, offset and be mounted the
same way as the one it replaces.
6-42
Page view 257
1 2 ... 253 254 255 256 257 258 259 260 261 262 263 ... 355 356

Comments to this Manuals

No comments