Boss Audio Systems 810DBI Owner's Manual download pdf (Page 3)

INSTALLA

TION

Notes:

y Choose the mounting location where

the unit will not interfere with the normal

driving func

tion of the driver.

y Before finally installing the unit, connect

the wiring temporarily and make sure it

is all connected up properly and the

unit and the system work properly.

y Use only the parts included with the

unit to ensure proper installation. The

use of unauthorized parts can cause

malfunctions.

y Consult with your nearest dealer if

installation requires the drilling of holes

or other modifications of the vehicle.

y Install the unit where it does not get in

the driver’s way and cannot injure the

passenger if there is a sudden stop, like

an emergency stop.

y If installation angel exceeds 30° from

horizontal, the unit might not give its

optimum performance.

y Avoid installing the unit where it would

be subject to high temperature, such as

from direct sunlight, or hot air, from the

heater, or where it would be subject to

dust, dirt or excessive vibration.

DIN FRONT-MOUNT (Method A)

Installing the unit

(1) Metal Strap

Be sure to use the strap to secure the

back of the unit of the place. The strap

can be bent by hand to the desired

angle.

(2) Mounting Bolt

(3) Hex Nut

(4) Spring Washer

(5) Tapping Screw

(6) Plain Washer

(a) Dashboard

(b) Holder

After inserting the holder into the

dashboard, select the appropriate tab

according to the thickness of the

dashboard material and bend them

inwards to secure the holder in place.

Removing the unit

Insert both of the supplied keys into the

slots at the middle left and right sides of the

unit, then pull the unit out of the dashboard.

DIN REAR-MOUNT (Method B)

If your vehicle is a Nissan, Toyota, follow

these mounting instructions.

Use the screw holes marked T (Toyota), N

(Nissan) located on both sides of the unit to

fasten the unit to the factory radio mounting

brackets supplied with your vehicle.

30

a

b

1 2 3 4 5 6 7 8 ... 16 17

Comments to this Manuals

No comments